Hyundai Ioniq: General Information / Basic Service Symbols
Hyundai Ioniq (AE) 2017-2024 Service Manual / General Information / Basic Service Symbols
General information
Tightening Torque Table of Standard Parts
Bolt (Nominal diameter)
Nut (Nominal diameter)
Bolt/ Nut Normal screw
Torque Nm (kg...
General information
Basic Service SymbolsThere are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service...
Other information:
Hyundai Ioniq (AE) 2017-2024 Service Manual: Rear Assist Arm. Repair procedures
Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the rear wheel and tire (A) from the rear hub. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft) • Be careful not to damage the hub bolts when removing the rear wheel and tire (A)...
Hyundai Ioniq (AE) 2017-2024 Owner's Manual: Certification label
The certification label is located on the driver's door sill at the center pillar and shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Vehicle Weight Rating). The GVWR includes the weight of the vehicle, all occupants, fuel and cargo...
Categories
- Manuals Home
- 1st Generation Ioniq Owners Manual
- 1st Generation Ioniq Service Manual
- Folding the side view mirrors
- Reverse Parking Aid Function
- Smart Cruise Control System
- New on site
- Most important about car
Tilt Steering / Telescope Steering
Adjust the steering wheel so it points toward your chest, not toward your face. Make sure you can see the instrument cluster warning lights and gauges. After adjusting, push the steering wheel both up and down to be certain it is locked in position. Always adjust the position of the steering wheel before driving.
WARNING
NEVER adjust the steering wheel while driving. This may cause loss of vehicle control resulting in an accident.
Copyright © 2024 www.hioniqae.com