| Replacement |
|
| 1. | Using a flat-tip screwdriver or remover, remove the gear knob & boot (A).
|
| 2. | Remove the gear knob & boots (A) pull both of it up.
|
| 3. | Using a flat-tip screwdriver or remover, remove the console upper cover (A).
|
| 4. | Press the lock pin and separate the connectors (A).
|
| 5. | Separate the power outlet connector (A).
|
| 6. | Remove the storage box pad (A).
|
| 7. | Loosen the mounting clip and remove the console side cover (A).
|
| 8. | Loosen the mounting bolts, screws and remove the console complete assembly (A).
|
| 9. | To install, reverse the removal procedure.
|
Components1. Console complete assembly2. Console tray mat3. Console upper complete assembly 4. Floor console tray assembly 5. Front console side cover [LH]6.
Component Location 1. Rear console cover
InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.
DescriptionThe smart cruise control unit is installed on the front right side of the chassis. A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects in front of the vehicle. The radar sensor can detect up to 64 objects ahead of a vehicle.