Hyundai Ioniq: Advanced Driver Assistance System (ADAS) / High voltage shut-off procedures
| High Voltage Shut-off Procedures |
| •
| Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries. |
| •
| Be sure to read and follow the "High Voltage Shut-off Procedures" before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries. |
|
| •
| High voltage components : High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc. |
|
| 1. | Turn the ignition switch OFF and disconnect the auxiliary (-) battery negative (-) terminal. |
| 2. | Remove the safety plug cover (A). 
|
| 3. | Unfasten the hook (A) and then remove the safety plug (C) by pulling the lever (B) to the direction of arrow. 
|
| 4. | Wait for more than 5 minutes so that the capacitor in the high voltage system can be fully discharged. |
| 5. | Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely. | (1) | Remove air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner") |
| (2) | Disconnect the inverter power cable (A). 
| •
| Disconnect the inverter power cable as the procedures below. |
|
|
| (3) | Measure the voltage between the inverter (+) terminal and the inverter (-) terminal. Less than 30V : More than 30V : Fault on high voltage circuit |
| •
| If measured more than 30V, check if the safety plug is removed completely.If measured more than 30V despite the safety plug is removed, there can be serious problems on the high voltage circuit. In this case, check DTC and never touch the high voltage system circuits. |
|
|
|
Safety PrecautionPrecautions To Take Before Servicing High Voltage System
•
Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a serious accidents like electric shock and electric leakage...
Special Service Tools
Tool Name / Number
Illustration
Description
LKA Compensator(09964-C1100)Used for compensating front view camera unitBCW Sensor Correction Tool Set(09958-3T500)Used to correct the blind-spot radar unit...
Other information:
Service Point Target Auto Calibration (SPTAC)When you need calibration :–
Front view camera is removed and mounted–
Replace front view camera with a new one –
Windshield glass changed–
Front view camera coupler of the windshield glass is deformedService Point Target Auto Calibration (SPTAC)Front view camera SPTAC provides the method for the service technician to calibrate the camera by aligning the calibration target (SST: 09890-3V100) with the vehicle on a level ground...
Switching to Hybrid mode to lubricate engine (Plug-in hybrid vehicle)
This message is displayed when the vehicle is automatically switched to the HEV
mode to lubricate engine while the Engine Start/Stop button is in the ON position.
Maintaining Hybrid mode to protect engine (Plug-in hybrid vehicle)
This message is displayed when the [EV/HEV] button is pressed but it is impossible
to switch from the HEV mode to EV mode due to engine lubrication...
Categories
The front seat can be adjusted by using the levers located on the outside of
the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
Forward and rearward adjustment
read more
General safety information and caution
Special service tools