Hyundai Ioniq: Gauges and Meters / Odometer & Range
Odometer
The odometer indicates the total distance that the vehicle has been driven and
should be used to determine when periodic maintenance should be performed.
Range
- The range is the estimated distance the vehicle can be driven with the remaining
fuel.
- If the estimated distance is below 1 mi. (1 km), the trip computer will
display "----" as range.
- The Range for cluster type B is displayed differently according to the mode
selected, ECO or SPORT. If the shift lever is in S (Sport), SPORT mode is selected
and if the shift lever is in D (Drive), ECO mode is selected.
- The Range for cluster type A is mentioned in "Trip Computer" in this chapter.
Information
- If the vehicle is not on level ground or the battery power has been interrupted,
the range function may not operate correctly.
- The range may differ from the actual driving distance as it is an estimate
of the available driving distance.
- The trip computer may not register additional fuel if less than 1.6 gallon
(6 liters) of fuel are added to the vehicle.
- The range may vary significantly based on driving conditions, driving
habits, and condition of the vehicle.
This gauge indicates the current outside air temperatures by 1°F (1°C).
- Temperature range : -40°F ~ 140°F (-40°C ~ 60°C)
The outside temperature on the display may not change immediately like a general
thermometer (to avoid distracting the driver)...
This indicator displays which shift lever position is selected.
Shift indicator pop-up (if equipped)
The pop-up indicates the current gear position displayed in the cluster for about
2 seconds when shifting into other positions (P/R/N/D)...
Other information:
Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel (A).(Refer to Body - "Crash Pad Lower Panel")3.Disconnect the rheostat switch connector (A).4.Operate the BSD switch, then check for continuity between terminals of BSD switch connector...
Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier...
Categories
Seat belt warning light
As a reminder to the driver, the seat belt warning light will illuminate and
warning chime will sound for approximately 6 seconds each time you place the Engine
Start/Stop button to the ON position if the seat belt is unfastened.
read more