| Removal |
| 1. | Disconnect (-) battery terminal. |
| 2. | Using a fastener remover (C), remove the mirror (A) as illustration below.
|
| 3. | Disconnect heat wire connectors (A) and then remove the mirror.
|
| 4. | Remove the mirror actuator mounting screw.
|
| 5. | Insert the fastener remover into the end of the mirror actuator (A) and lift it up.
|
| 6. | Disconnect the connector (A) and then remove the mirror actuator.
|
| Installation |
| 1. | Connect the actuator connector and then install the mirror actuator. |
| 2. | Connect mirror heat wire connector and then install the mirror. |
| 3. | Connect (-) battery terminal then check if mirror works normally. |
Inspection[Power Window Switch]1.Disconnect the negative (-) battery terminal.2.Remove the driver door trim.(Refer to Body - "Front Door Trim")3.Disconnect the power mirror switch connector from the door trim.
Components1. BSD Indicator2. Side repeater lamp3. Puddle lamp
Inspection1.Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature.1. Ambient Sensor (+)2. Sensor groundSpecification Ambient temperature [°C (°F)] Resistance between terminal 1 and 2 (
Removal1.Disconnect the negative (-) battery terminal.2.Remove the steering wheel assembly.(Refer to Steering System - "Steering Wheel")3.Remove the steering back cover (A).4.Remove the steering remote control connector (A).5.Remove the steering remote control after loosening the screws.