The sunroof may need to be reset if the following conditions occur:
- The battery is discharged or disconnected or the sunroof fuse has been replaced
or disconnected
- The sunroof control lever is not operating correctly
To reset the sunroof, perform the following steps:
1. Place the Engine Start/Stop button to the ON position or start the vehicle
(
indicator ON). It is recommended to
reset the sunroof while the vehicle is in the ready (
)
mode.
2. Push the control lever forward.The sunroof will close completely or tilt depending on the condition of the sunroof.
3. Release the control lever when the sunroof stops moving.
4. Push the control lever forward about 10 seconds.
- When the sunroof is in the closed position :
The glass will tilt and slightly move up and down.
- When the sunroof is in the tilt position:
The glass will slightly move up and down.
Do not release the lever until the operation is completed.
If you release the lever during operation, start the procedure again from step 2.
5. Within 3 seconds, push and hold the control lever forward until the sunroof operates as follows:
Tilt down → Slide Open → Slide Close.
Do not release the lever until the operation is completed.
If you release the lever during operation, start the procedure again from step 2.
6. Release the sunroof control lever after all steps have completed. The sunroof system has been reset.
Information
The sunshade will open automatically with the sunroof when the glass panel moves. If you want it closed, move the sunshade manually. NOTICE The sunroof is made to slide together with the sunshade.
General Safety Information and CautionBe careful of the following precautions when driving the vehicle using the smart cruise control system. • The smart cruise control system may have limits in detecting distance to the vehicle ahead due to road and traffic conditions.
RemovalWarning Indicator1.Disconnect the negative (-) battery terminal.2.Remove the mirror (A).InstallationWarning Indicator1.Install the outside mirror.2.Connect the negative (-) battery terminal.Inspection1.Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.