Hyundai Ioniq: Lighting System / Room Lamp. Repair procedures
[Room Lamp]
1. | Disconnect the negative (-) battery terminal. |
2. | Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp. •
| Put on gloves to prevent hand injuries. |
•
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
|
|
3. | If it is necessary to replace the bulb, remove the bulb (A) after disengaging the room lamp lens. |
4. | Disengage the room lamp (B) after loosening the mounting screws. •
| When removing the room lamp, be careful of the direction in which the tool is inserted. |
•
| Use caution when inserting the tool in the opposite direction, as the room lamp is damaged. |
|
|
5. | Remove the room lamp assembly after disconnect the room lamp connector. |
[Vanity Lamp]
1. | Separate the vanity Lamp (A) from the roof trim after disengaging the mounting clip (B). |
[Room Lamp]
1. | Install the room lamp after connect the connector. |
2. | Install the room lamp lens |
3. | Connect the negative (-) battery terminal. |
[Vanity Lamp]
1. | Install the vanity lamp. |
2. | Connect the negative (-) battery terminal. |
Head Lamp Aiming Instructions[Mechanical Aiming]The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions...
Inspection1.Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch...
Other information:
Rear View Monitor
The Rear View Monitor will activate when the vehicle is in the ready ()
mode and when you shift to the R (Reverse) position.
This is a supplemental system that helps provide a view of the area behind the
vehicle through the A/V display while the vehicle is in the R (Reverse) position...
Replacement
•
If a DTC occurs in the ECU, check the connectors and wiring. If no problem is found, replace the ECU.
•
Before replacing the MDPS ECU, use the diagnostic device to read the settings of the old ECU1...
Categories
The seatback pocket is provided on the back of the front passenger's seatback.
WARNING
To prevent the Occupant Classification System from malfunctioning:
read more