Hyundai Ioniq: Lane Keeping Assist (LKA) System / Warning Light and Message
Check Lane Keeping Assist (LKA) system
If there is a problem with the system a message will appear for a few seconds.
If the problem continues the LKA system failure indicator will illuminate.
LKA system failure indicator
The LKA system failure indicator (yellow) will illuminate if the LKA system is
not working properly. Have your vehicle checked by an authorized HYUNDAI dealer.
When there is a problem with the system do one of the following:
- Turn the system on after turning the engine off and on again.
- Check if the ignition switch is in the ON position.
- Check if the system is affected by the weather. (ex: fog, heavy rain, etc.)
- Check if there is foreign matter on the camera lens.
If the problem is not solved, have your vehicle checked by an authorized HYUNDAI
dealer.
The system will be cancelled when:
- You change lanes with the turn signal.
- Using the turn signal to change lanes.
- If you change lanes without the turn signal on, the steering wheel might be
controlled.
- LKA system can transit to steering assist mode when the car is near to middle
of the lane after system on or the lane was changed. LKA system can not assist
steering if the vehicle follows lane marker too close continuously before transition
to steering assist mode.
- The control of ESC (Electronic Stability Control) or VSM (Vehicle Stability
Management) is activated.
- The steering will not be assisted when your drive fast on a sharp curve.
- The steering will not be assisted when vehicle speed is below 40 mph (64
km/h) and over 110 mph (177 kph).
- The steering will not be assisted when you change lanes fast.
- The steering will not be assisted when you brake suddenly.
- The steering will not be assisted when the lane is very wide or narrow.
- The steering will not be assisted when only one side lane marker is detected.
- There are more than two lane markers such as a construction area.
- Radius of a curve is too small.
- When you turn steering wheel suddenly, the LKA system will be disabled temporarily.
- Driving on a steep slope or hill.
To see the LKA system screen on the LCD display in the cluster, select SCC/LKA
mode () for cluster type A or ASSIST
mode () for cluster type B. For
more information, refer to "LCD Display Modes" in chapter 3...
When lane and road condition is poor
It is difficult to distinguish the lane marker from road when the lane marker
is covered with dust or sand.
It is difficult to distinguish the color of the lane marker from road...
Other information:
DescriptionPurge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in the canister is transferred to the intake manifold...
Removal and Installation1.Disconnect the battery negative terminal.2.Remove the engine room under cover.(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")3.Disconnect the oil pressure switch connector (A).4.Remove the oil pressure switch (A)...
Categories
Folding the rear seat
The rear seatbacks can be folded to facilitate carrying long items or to increase
the luggage capacity of the vehicle.
WARNING
Never allow passengers to sit on top of the folded down seatback while
the vehicle is moving. This is not a proper seating position and no seat belts
are available for use. This could result in serious injury or death in case
of an accident or sudden stop.
Objects carried on the folded down seatback should not extend higher
than the top of the front seatbacks. This could allow cargo to slide forward
and cause injury or damage during sudden stops.
read more