Hyundai Ioniq: High Voltage Battery Control System / Components and components location
1. BMS ECU 2. Power Relay Assembly (PRA) 3. Safety Plug
| 4. Battery Temperature Sensor 5. Battery Ambient Sensor
|
•
| Main Relays (Positive, Negative), Pre-Charge Relay, Pre-Charge Resistor, and Battery Current Sensor are integrated into the PRA. |
|
SpecificationSafety Plug▷ Specification
Item
Specification
Rated Voltage (V) 400 Rated Current (A) 80 Fuse Rated Current (A) 125 Fuse Melting Time Rated Current x 110% Min...
Other information:
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Replacement1.Remove the rear door module.(Refer to Rear Door - "Rear Door Module")2.Remove the rear door inside handle cage (A).3.Loosen the mounting bolt and remove the rear door latch (A).4.Disconnect the rear door latch connector (A).5.Remove the rear door outside handle base (A) by pushing in the lock pins located in the back...
Categories
Adjust the steering wheel so it points toward your chest, not toward your face.
Make sure you can see the instrument cluster warning lights and gauges. After adjusting,
push the steering wheel both up and down to be certain it is locked in position.
Always adjust the position of the steering wheel before driving.
WARNING
NEVER adjust the steering wheel while driving. This may cause loss of vehicle
control resulting in an accident.
read more