Hyundai Ioniq: Forward Collision-Avoidance Assist (FCA) system / FCA Sensor
In order for the FCA system to operate properly, always make sure the radar sensor
cover is clean and free of dirt, snow, and debris. Dirt, snow, or foreign substances
on the lens may adversely affect the sensing performance of the sensor.
NOTICE
- Do not apply license plate frame or foreign objects such as a bumper
sticker or a bumper guard near the radar sensor. Doing so may adversely affect
the sensing performance of the radar.
- Always keep the radar sensor and cover clean and free of dirt and debris.
- Use only a soft cloth to wash the vehicle. Do not spray pressurized water
directly on the sensor or sensor cover.
- Be careful not to apply unnecessary force on the radar sensor or sensor
cover. If the sensor is forcibly moved out of proper alignment, the FCA system
may not operate correctly. In this case, a warning message may not be displayed.
Have the vehicle inspected by an authorized HYUNDAI dealer.
- If the front bumper becomes damaged in the area around the radar sensor,
the FCA system may not operate properly. Have the vehicle inspected by authorized
HYUNDAI.
- Use only genuine parts to repair or replace a damaged sensor or sensor
cover. Do not apply paint to the sensor cover.
NOTICE
- NEVER install any accessories or stickers on the front windshield, nor
tint the front windshield.
- NEVER locate any reflective objects (i.e. white paper, mirror) over the
dashboard. Any light reflection may cause a malfunction of the system.
- Pay extreme caution to keep the camera out of water.
- NEVER disassemble the camera assembly, nor apply any impact on the camera
assembly.
- Playing the vehicle audio system at high volume may offset the system
warning sounds.
Information
Have the system checked by an authorized HYUNDAI dealer when:
- The windshield glass is replaced.
- The front bumper is replaced.
- The sensor cover or sensor gets damaged or replaced.
The FCA produces warning messages and warning alarms in accordance with the collision
risk levels, such as abrupt stopping of the vehicle in front, insufficient braking
distance, or pedestrian detection...
Forward Collision-Avoidance Assist (FCA) system disabled. Radar blocked
When the sensor cover is blocked with dirt, snow, or debris, the FCA system operation
may stop temporarily...
Other information:
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door...
Component location1. HPCU (Hybrid Power Control Unit)(LDC+MCU+HCU+Reservoir)2. Hybrid drive motor3. Hybrid starter generator (HSG)4. Electrical radiator5. Electric water pump (EWP)Components1. HPCU (Hybrid Power Control Unit)2. HPCU tray3. HPCU cover4...
Categories
1. Door lock/unlock button
2. Driver position memory system
3. Side view mirror control switch
4. Central door lock switch
read more