| Replacement |
| 1. | Pull down the front door window glass to the lowest level by pressing the power window glass switch. |
| 2. | After loosening the mounting screws, remove the front door belt outside weatherstrip (A).
|
| 3. | To install, reverse the removal procedure.
|
Replacement1.Remove the plug hole (B).2.After loosening the mounting bolt, remove the front door lock assembly (A). Tightening torque : 7.
Replacement1.Remove the front door trim.(Refer to Front Door - "Front Door Trim")2.Remove the front door belt inside weatherstrip (A).3.To install, reverse the removal procedure.
Inspection1.Connect the battery voltage and check the blower motor rotation.2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.3.Replace the blower motor if it is proved that there is a problem with it.
Self Diagnosis1.Self-diagnosis process. • When operating the self-diagnostics, the below fault (self-diagnostics code) will blink at 0.5 seconds interval on the temperature display settings (driver's side only) and the remaining symbols are OFF .