| Inspection |
| 1. | There should be continuity between the No.17 and No.16 terminals when power and ground are connected to the No.17and No.19 in the ICM-B. |
| 1. | There should be continuity between the No.6 and No.8 terminals when power and ground are connected to the No.15and No.17in the ICM-B. |
DescriptionThe ICM is united with many kinds of relays and installed over the instrument panel box.
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.Verify that the temperature control actuator operates to the warm position when connected in reverse.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear bumper.(Refer to Body - "Rear Bumper")3.Remove the rear corner radar unit (A) after loosening the mounting nuts. • Take care not to separate the bracket from rear bumper when removing the rear corner radar sensor.