Hyundai Ioniq (AE): Front Door / Front Door Inside Handle. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body (Interior and Exterior) / Front Door / Front Door Inside Handle. Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
After loosening the mounting screws, remove the front door inside handle (A).

3.
To install, reverse the removal procedure.
   
•
Make sure the door locks / unlocks and opens / closes properly.
•
Replace any damaged clips (or pin-type retainers).

    Replacement    â€¢ Put on gloves to prevent hand injuries.    â€¢ When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Component Location 1. Front door window glass

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Heater Unit. Components and components location

    Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Unit. Components and components location

    Component Location1. Blower unit assembly Components1. Duct Seal2. Intake duct case3. Air intake door assembly4. Intake door5. Seal6. Intake duct case (A)7. Air filter cover (A)8. Intake actuator9. Air filter cover10. Air filter 11. Blower unit pad12.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.018