Hyundai Ioniq: Front Door / Front Door Trim. Repair procedures
•
| Put on gloves to prevent hand injuries. |
|
•
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
•
| Be careful not to scratch the door trim and other parts. |
|
1. | Using a screwdriver or remover, remove the front door quadrant inner cover (A). 
|
2. | After loosening the mounting screws, remove the lower part of the front door trim (A) using a flat-tip screwdriver. 
|
3. | Remove the front door inside handle cage (A). 
|
4. | Disconnect the front door lamp connector (A) and power window switch connector (B). 
|
5. | To install, reverse the removal procedure. •
| Make sure the connector is connected properly. |
•
| Make sure the door locks / unlocks and opens / closes properly. |
•
| Replace any damaged clips (or pin-type retainers). |
•
| Make sure the glass is operated properly. |
|
|
Replacement1.Remove the front door trim.(Refer to Front Door - "Front Door Trim")2.After loosening the mounting screws, remove the front door inside handle (A)...
Other information:
Inspection[Fuel Sender] 1.Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level. Pin No Discription 1Fuel sender ground 2Fuel pressure sensor (FPS) signal input 3Fuel pressure sensor (FPS) ground (-) 4Ground 5CAN [Low] 6Fuel sender signal 7- 8Fuel pressure sensor (FPS) Power supply (+5V) 9CAN [High] 10Battery power (B+) 2...
S..
Categories
Seat belt warning light

As a reminder to the driver, the seat belt warning light will illuminate and
warning chime will sound for approximately 6 seconds each time you place the Engine
Start/Stop button to the ON position if the seat belt is unfastened.
read more