Hyundai Ioniq: Seat Electrical / Power Seat Control Switch. Schematic diagrams

Power Seat Motor. Repair procedures

InspectionDiagnosis with GDS1.The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).The diagnostic system (GDS) provides the following information...

Power Seat Control Switch. Repair procedures

InspectionSeat Control Switch1.With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch...

Other information:

Hyundai Ioniq (AE) 2017-2025 Service Manual: HCU (Hybrid Control Unit). Schematic diagrams

HCU Terminal and Input / Output SignalTerminal FunctionConnector [C133-S] Pin No Description Connected to 1HCU GroundChassis ground2HCU GroundChassis ground3HCU GroundChassis ground4Battery power (B+)Battery5Battery power (B+)Battery6Battery power (B+)Battery7-　8-　9-　10-　11-　12-　13-　14-　15Brake Switch 2 signal inputBrake Switch (NC, IG1)16Brake Switch 1 signal inputBrake Switch (NO, B+)17-　18-　19-　20-　21-　22-　23-　24-　25-　26-　27-　28-　29-　30-　31-32-33-34-　35-　36-　37-　38Start signal inputSmart Key Unit39-　40-　41-　42-　43-　44-　45-　46-　47-　48-　49-　50-　51-　52-　53-　54-　55-　56-　57-　58-　59-　60-　61-　62-　63-　64-　65-　66-　67-　68-　69-　70-　71-　72-　73IGN signal inputSmart Key Unit74-　75-　76-　77-　78Powertrain CAN [High] signal inputOther control modules79Powertrain CAN [Low] signal inputOther control modules80-　81Hybrid CAN [High] signal inputOther control modules82Hybrid CAN [Low] signal inputOther control modules83-　84-　85-　86-　87-　88-　89-　90-　91-　92-　93-　94-　Input/Output signalConnector [C133-S] Pin no Description Condition Type Level 1HCU GroundAlwaysDC VoltageMax...

Hyundai Ioniq (AE) 2017-2025 Service Manual: Rear Door Belt Inside Weatherstrip. Repair procedures

Replacement1.Remove the rear door trim.(Refer to Rear Door - "Rear Door Trim")2.Remove the rear door belt inside weatherstrip (A).3.To install, reverse the removal procedure.    • When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame...