Hyundai Ioniq: Seat Electrical / Power Seat Control Switch. Repair procedures
Seat Control Switch
1. | With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. [Power Seat Control Switch] |
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the front seat outer shield cover. (Refer to Body - "Front Seat Outer Shield Cover") |
3. | Remove the power seat control switch (A) after loosening the screws. |
1. | Install the power seat control switch after connecting the connector. |
2. | Install the front seat outer shield cover. |
3. | Connect the negative (-) battery terminal. |
Component Location[Front Seat Heater (Non-Air ventilation)]1. Seat heater unit (Passenger seat only)2. Seat chusion heater3. Seat back (Heater)[Front Seat Heater (Air ventilation)]1...
Other information:
The sensors are located inside the rear bumper.
Always keep the rear bumper clean for the proper operation of the system.
Warning message
Blind-Spot Collision Warning (BCW) system disabled. Radar blocked
This warning message may appear when : - One or both of the sensors on the rear
bumper is blocked by dirt or snow or a foreign object...
General Troubleshooting InformationBefore Troubleshooting1.Check applicable fuses in the appropriate fuse/relay box.2.Check the battery for damage, state of charge, and clean and tight connections.(Refer to Engine Electrical System - "Battery")
•
Do not quick-charge a battery unless the battery ground cable has been disconnected, otherwise you will damage the alternator diodes...
Categories
The front seat can be adjusted by using the levers located on the outside of
the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
Forward and rearward adjustment
read more