Hyundai Ioniq: Interior Trim / Rear Transverse Trim. Components and components location
Replacement[Center pillar lower trim]
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Other information:
Inspection1.Turn the ignition switch OFF.2.Disconnect the injector connector.3.Measure resistance between the injector terminals 1 and 2.4.Check that the resistance is within the specification. Specification : Refer to "Specification"Removal
•
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel...
Removal1.Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")2.Turn the ignition switch OFF, and then remove battery (-) cable. 3.Disconnect the fuel feed tube quick-connector (A).
•
Open the clamp cover (B) before disconnect the quick connector...
Categories
Adjust the steering wheel so it points toward your chest, not toward your face.
Make sure you can see the instrument cluster warning lights and gauges. After adjusting,
push the steering wheel both up and down to be certain it is locked in position.
Always adjust the position of the steering wheel before driving.
WARNING
NEVER adjust the steering wheel while driving. This may cause loss of vehicle
control resulting in an accident.
read more