| Adjustment |
| 1. | Place the car on a flat surface and check whether the body and trunk lid are well-aligned. |
| 2. | After loosening the tailgate hinge (A) mounting bolt, adjust the tailgate by moving it up and down or from side to side. |
| 3. | Adjust the gap between the tailgate and body by turning the tailgate overslam bumpers (B). |
| 4. | After loosening the tailgate striker (C) mounting bolts, adjust the striker by moving it back and forth or from side to side and then tighten the mounting bolts. |
| 5. | Make sure the tailgate opens or closes properly. |
| 6. | Make sure the guide bumper (D) overlap each other is good.
|
Component Location1. Tailgate assembly
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.Verify that the temperature control actuator operates to the warm position when connected in reverse.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear bumper.(Refer to Body - "Rear Bumper")3.Remove the rear corner radar unit (A) after loosening the mounting nuts. • Take care not to separate the bracket from rear bumper when removing the rear corner radar sensor.