Hyundai Ioniq: Horn / Repair procedures
1. | Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") |
2. | Remove the horn after loosening the mounting the bolt. |
[Low Pitch Horn]

[High Pitch Horn]

1. | Install the horns after connect the horn connectors. |
2. | Install the front bumper cover. |
1. | In this vehicle, the horn relay is mounted in the PCB block of the engine compartment relay block. |
•
| The semiconductor relay inserted in the PCB cannot be replaced. |
•
| If you need to replace the relay, replace the PCB block and perform the test. |
|
Other information:
Description•
The front impact sensors (FIS) are installed on the upper of the side panel in Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at their mounting locations.•
The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collition...
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Categories
Folding the rear seat
The rear seatbacks can be folded to facilitate carrying long items or to increase
the luggage capacity of the vehicle.
WARNING
Never allow passengers to sit on top of the folded down seatback while
the vehicle is moving. This is not a proper seating position and no seat belts
are available for use. This could result in serious injury or death in case
of an accident or sudden stop.
Objects carried on the folded down seatback should not extend higher
than the top of the front seatbacks. This could allow cargo to slide forward
and cause injury or damage during sudden stops.
read more