| Circuit Diagram |

Component Location1. Sunroof2. Sunroof switch3. Sunroof motor & controller
Inspection1.Disconnect the negative (-) battery terminal.2.Open the sunglass case cover from the overhead console and remove the 2 screws holding the overhead console.
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Inspection1.Turn the ignition switch OFF.2.Disconnect the mode control actuator connector.3.Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.Verify that the mode control actuator operates to the vent mode when connected in reverse.