Hyundai Ioniq (AE): Heated Steering wheel / Specifications
| Specifications |
|
Item
|
Specification
|
| Voltage | 13.5 V |
| Heated pad resistance | 1.8 Ω ± 0.2 Ω |
| NTC resistance | 10.0 kΩ ± 10% (25°C) |
DescriptionFor the convenience of drivers during the winter, exothermic paint is applied to the surface of the steering wheel to generate heat when it is gripped.
System Circuit DiagramBody control ModuleHeated steering switchHeated steering padTermainal functionBody control module Pin Function D3Ignition 2_Heated handle powerD4Ignition 2_Heated handle power_2D5Heated handleC22NTC (-)C9NTC (+)C4Heated handle switchHeated steering wheel pad Housing Pin Function Wire color PadAGroundBLACKBHEATERYELLOWCNTC+GRAYDNTC-BLACKHeated steering wheel switch Pin Function 7Wheel heated12Wheel heated IND.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Mode Control Actuator. Description and operation
DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Warning Indicator. Repair procedures
RemovalWarning Indicator1.Disconnect the negative (-) battery terminal.2.Remove the mirror (A).InstallationWarning Indicator1.Install the outside mirror.2.Connect the negative (-) battery terminal.Inspection1.Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- If the 12 Volt Battery is Discharged (Hybrid Vehicle)
- Repair procedures
- Engine Clutch System
- New on site
- Most important about car
