Hyundai Ioniq: Warning and Indicator Lights / Electronic Brake Force Distribution (EBD) System Warning Light
These two warning lights illuminate at the same time while driving:
• When the ABS and regular brake system may not work normally. In this case,
have the vehicle inspected by an authorized HYUNDAI dealer.
WARNING
Electronic Brake Force Distribution (EBD) System Warning Light
When both ABS and Parking Brake & Brake Fluid Warning Lights are on, the brake
system will not work normally and you may experience an unexpected and dangerous
situation during sudden braking.
In this case, avoid high speed driving and abrupt braking.
Have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.
Information - Electronic Brake Force Distribution (EBD) System Warning Light
When the ABS Warning Light is on or both ABS and Parking Brake & Brake Fluid
Warning Lights are on, the speedometer, odometer, or tripmeter may not work. Also,
the EPS Warning Light may illuminate and the steering effort may increase or decrease.
In this case, have the vehicle inspected by an authorized HYUNDAI dealer as
soon as possible.
Regenerative Brake Warning Light
This warning light illuminates :
When you place the Engine Start/ Stop button to the ON position.
- It illuminates for approximately 3 seconds...
Electric Power Steering (EPS) Warning Light
This warning light illuminates:
When you place the Engine Start/ Stop button to the ON position.
- It illuminates for approximately 3 seconds and then goes off...
Other information:
Inspection[Battery Pack Assembly Troubleshooting Chart]
•
For SOC check, refer to "SOC Inspection"•
For voltage check, refer to "Battery Voltage Inspection"•
For battery voltage sensing circuit, refer to "Voltage Sensing Circuit Inspection"•
For isolation resistance check, refer to "Isolation Resistance Inspection" [SOC Level and Follow-up] SOC Symptom Warning Lamp Follow-up MIL Service Fuel •
Normal --- 10 - 15% •
Motor torque limite (Acceleration delay)--ON•
Refuel and check the SOC againON--•
Repair the MIL or Service Lamp related system•
Charge the battery by starting the engine•
Refuel if necessary ONON--ON-OnONON 5 - 10% •
EV Mode inhibited •
FATC Inhibited •
LDC Inhibited --ON•
Refuel and check the SOC againON--•
Repair the MIL or Service Lamp related system•
Charge the battery by starting the engine •
Refuel if necessaryONON--ON-ONONON 0 - 5% •
Impossible to start ON--•
Repair the MIL or Service Lamp related system•
Start the engine with GDS to charge the battery•
Refuel if necessary ONON--ON-ONONON 0% ON--•
Repair the MIL or Service Lamp related system•
If necessary, Replace Battery Pack•
Refuel if necessary [SOC Inspection]1...
Replacement1.Remove the rear door trim.(Refer to Rear Door - "Rear Door Trim")2.Remove the rear door belt inside weatherstrip (A).3.To install, reverse the removal procedure.
•
When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame...