Hyundai Ioniq: Side View Mirrors / Side view mirror control
Adjusting the side mirrors:
1. Press either the L (driver's side) or R (passenger's side) button (1) to select
the side view mirror you would like to adjust.
2. Use the mirror adjustment control switch to position the selected mirror up,
down, left or right.
3. After adjustment, put the button into neutral (center) position to prevent
inadvertent adjustment.
NOTICE
- The mirrors stop moving when they reach the maximum adjusting angles,
but the motor continues to operate while the switch is pressed. Do not press
the switch longer than necessary, because this can damage the motor.
- Do not attempt to adjust the side view mirrors by hand, because this
can damage the motor.
The Blind Spot Mirror (BSM) is a supplemental mirror that reduces the driver’s
blind spot by showing the rear side area of the vehicle. The blind spot mirror is
equipped on the left-hand side view mirror...
Other information:
PrecautionsGeneral PrecautionsPlease read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries.•
Except when performing electrical inspections, always turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at least three minutes before beginning work...
Hub nut tightening sequenceTighten the hub nuts as follows. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
•
When using an impact gun, final tightening torque should be checked using a torque wrench...
Categories
1. Door lock/unlock button
2. Driver position memory system
3. Side view mirror control switch
4. Central door lock switch
read more