Hyundai Ioniq: Hood / Hood Latch. Components and components location

Replacement1.Using a socket (B), remove the hood release handle (A).2.To install, reverse the removal procedure.
•
Make sure the hood latch cable is connected properly...
Replacement1.Disconnect the connector (A), then remove the wiring mounting clips.2.Disconnect the hood latch release cable (A). 3.Loosen the mounting bolts and remove the hood latch assembly (A)...
Other information:
Signal WaveformThis example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. The PCM controls the injection and ignition timing by using these signals. Generally CKPS signal is used to detect the piston's position and CMPS signal is used to detect the Top Dead Center of each cylinder...
Removal1.Remove the fuel pump.(Refer to Fuel Delivery System - "Fuel Pump") 2.Disconnect the fuel pump motor connector (A) and fuel sender connector (B).3.Press the fixing hook (A) with a driver and then remove fuel sender (B) in the arrow direction.Installation1...
Categories

Adjusting the side mirrors:
1. Press either the L (driver's side) or R (passenger's side) button (1) to select
the side view mirror you would like to adjust.
read more