Hyundai Ioniq (AE): Body (Interior and Exterior) / Hood
- Repair procedures
- Hood Assembly. Components and components location
- Hood Insulator Pad. Repair procedures
- Hood Weatherstrip. Repair procedures
- Hood Latch Release Handle. Components and components location
- Hood Latch Release Handle. Repair procedures
- Hood Latch. Components and components location
- Hood Latch. Repair procedures
Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components• Put on gloves to prevent hand injuries • When removing the clips, use a clip remover.
Adjustment1.After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.2.Adjust the hood height by moving the hood overslam bumpers (C) up and down.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Front Radar Unit. Repair procedures
Removal1.Remove the front bumper.(Refer to Body - "Front Bumper")2.Disconnect the smart cruise control unit connector (A).3.Remove the smart cruise control nuit assembly (B) from thevehicle after loosening mounting bolts.Installation1.Install in the reverse order of removal.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Engine Clutch System
- Description and operation
- Suspension System
- New on site
- Most important about car
