Hyundai Ioniq: LCD Display Messages / Icy Road Warning Light

Hyundai Ioniq (AE) 2017-2024 Owner's Manual / Convenient features of your vehicle / Instrument Cluster / LCD Display Messages / Icy Road Warning Light

Hyundai Ioniq. Icy Road Warning Light

This warning light is to warn the driver the road may be icy.

When the temperature on the outside temperature gauge is approximately below 40°F (4°C), the Icy Road Warning Light and Outside Temperature Gauge blinks and then illuminates. Also, the warning chime sounds 1 time.

Information

If the icy road warning light appears while driving, you should drive more attentively and safely refraining from over-speeding, rapid acceleration, sudden braking or sharp turning, etc.

Door, Hood, Liftgate, Sunroof Open

Door, Hood, Liftgate Open This warning is displayed indicating which door, or hood, or liftgate is open. CAUTION Before driving the vehicle, you should confirm that the door/ hood/liftgate is fully closed...

Low Pressure, Turn on FUSE SWITCH/ Turn FUSE SWITCH On

Low Pressure This message is displayed if the tire pressure is low. The corresponding tire on the vehicle will be illuminated. Turn on FUSE SWITCH/ Turn FUSE SWITCH On Either message is displayed if the fuse switch located on the fuse box under the steering wheel is OFF...

Other information:

Hyundai Ioniq (AE) 2017-2024 Owner's Manual: Plug-in Hybrid Mode (Plug-in hybrid vehicle)

EV/HEV Button Pressing the [EV/HEV] button changes the plug-in hybrid system modes, between Electric (CD) mode and Hybrid (CS) mode. Each time the mode is changed a corresponding indicator is displayed on the instrument cluster as follows. Plug-in Hybrid Mode Indicator • CD (Charge Depleting, Electric) mode : The high-voltage (hybrid) battery is used to drive the vehicle...

Hyundai Ioniq (AE) 2017-2024 Service Manual: Sub Battery Pack Assembly (Sub-BPA). Repair procedures

Check the target charging voltage when replacing with a new module Fault Code1.Turn OFF the ignition switch.2.Connect the diagnostic tool device to the self-diagnosis connector (DLC).3.Turn ON the ignition switch.4.Check the "Fault Code" in the diagnostic tool fault diagnosis...