Hyundai Ioniq (AE): Tailgate / Tailgate Latch. Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the tailgate trim.
(Refer to Tailgate - "Tailgate Trim")
2.
Disconnect the tailgate latch connector (A).

3.
After loosening the mounting bolts, then remove the tailgate latch assembly (A).
Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)

4.
To install, reverse the removal procedure.
   
•
Make sure the tailgate locks / unlocks and opens / closes properly.
•
Adjust the tailgate alignment.
•
Make sure the connectors are connected in properly.

    Component Location 1. Tailgate latch assembly

    Replacement    â€¢ Take care to not let the tailgate fall on you as the lifts are removed. Have a helper hold the tailgate open, or use a secure method to hold it open.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Description and operation

    DescriptionThe auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mod

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Safety ON/OFF Switch. Repair procedures

    Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.4.Remove the rheostat switch connector (A).

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0158