Hyundai Ioniq: Tire Pressure Monitoring System / TPMS Receiver. Repair procedures
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the glove box. (Refer to Body - "Glove Box Upper Cover Assembly") |
3. | Remove the smart key unit. (Refer to Body - "Smart Key Unit") |
4. | Disconnect the body control module connectors (A). 
|
5. | Remove the body control module (A) after loosening the mounting nuts. 
|
1. | Install the body control module. |
2. | Install the glove box upper cover assembly. |
3. | Connect the negative (-) battery terminal. |
Diagnosis procedure by using diagnostic device |
As manual for diagnosis methods by using diagnosis device, the main contents are as follows :
1. | Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON. |
2. | Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK. [Sensor ID Writing] 

[Vehicle name input initialization] 

[VIN input initialization] 

|
Description TPMS Receiver : BCM(body control module) integrated management1.Mode(1)Virgin State–
The receiver as a sole part is shipped in this state...
Other information:
DescriptionAuto Cut System of Dark Current Abbreviation Expalnation AAFActive Air FlapACUAirbag Control UnitAEBAutonomous Emergency BrakingAHBActive Hybrid Brake SystemAMPAmplifierAVNHead Unit (Audio / AVN)B_CANBody Controller Area NetworkBCMBody Control ModuleBMSBattery Management SystemBSDBlind Spot DetectionC_CANChassis Controller Area NetworkCARMERARear View CarmeraCLUCluster ModuleDATCDual Automatic Temp ControlFPCMFuel Pump Control ModuleHPCUHybrid Power UnitIGPMIntergrated Gateway & Power control ModuleLDWSLane Departure Warning SystemM_CANMulti media Controller Area NetworkMDPSMotor Driven Power SteeringP_CANPowertrain Controller Area NetworkPASParking Assist SystemSJBSmart Junction BlockSMKSmart Key UnitTCM(DCT)Double Clutch Transmission UnitVESSVirtual Engine Sound SystemSmart Junction Block (SJB) General function : Interior Junction Block + some functions of BCMIt controls loads with CAN communication and IPS...
C..
Categories
The front seat can be adjusted by using the levers located on the outside of
the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
Forward and rearward adjustment

read more