Hyundai Ioniq: Rear Suspension System / Trailing Arm. Repair procedures

Hyundai Ioniq (AE) 2017-2025 Service Manual / Suspension System / Rear Suspension System / Trailing Arm. Repair procedures

Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from the rear hub.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)

   
•
Be careful not to damage the hub bolts when removing the rear wheel and tire (A).
3.
Loosen the trailing arm mounting nuts (A), and then remove the trailing arm.
Tightening torque :
137.3 - 156.9 N.m (14.0 - 16.0 kgf.m, 101.3 - 115.7 lb-ft)

4.
Remove the parking brake cable fromt the rear caliper.
(Refer to Brake System - "Rear disc brake")
5.
Loosen the wheel speed sensor cable bracket nut and then separate the cables with the trailing arm.
Tightening torque :
6.8 - 10.7 N.m (0.7 - 1.1 kgf.m, 5.0 - 7.9 lb-ft)

6.
Remove the parking brake cable bracket (A) and then separate the cables from the trailing arm.
Tightening torque :
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

7.
Loosen the mounting bolt and then remove the trailing arm from the frame.
Tightening torque :
98.1 - 117.7 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.8 lb-ft)

8.
Install in the reverse order of removal.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear lower arm for deformation..

    Rear Assist Arm. Repair procedures

    Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the rear wheel and tire (A) from the rear hub...

    Rear Coil Spring. Repair procedures

    Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the rear wheel and tire (A) from the rear hub...

    Other information:

    Hyundai Ioniq (AE) 2017-2025 Service Manual: Engine Control Module (ECM). Repair procedures


    Removal    • When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.[In the case of installing used ECM]1)Perform "ECM Neutral mode" procedure with GDS.(Refer to Body Electrical System - "Immobilizer System")2)After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS...

    Hyundai Ioniq (AE) 2017-2025 Owner's Manual: Plug-in Hybrid Mode (Plug-in hybrid vehicle)


    EV/HEV Button Pressing the [EV/HEV] button changes the plug-in hybrid system modes, between Electric (CD) mode and Hybrid (CS) mode. Each time the mode is changed a corresponding indicator is displayed on the instrument cluster as follows. Plug-in Hybrid Mode Indicator • CD (Charge Depleting, Electric) mode : The high-voltage (hybrid) battery is used to drive the vehicle...

    Categories

    Hybrid Vehicle Interior Overview

    Hyundai Ioniq. Hybrid Vehicle Interior Overview

    1. Door lock/unlock button
    2. Driver position memory system
    3. Side view mirror control switch
    4. Central door lock switch

    read more


     
    Copyright © 2025 www.hioniqae.com