Replacement1.Remove the front door module.(Refer to Front Door - "Front Door Module")2.Remove the front door inside handle cage (A).3.Remove the front door latch assembly (A) by pulling it in the direction of the arrow.
Components 1. Rear door trim2. Rear door pull cap3. Rear door module4. Rear door belt inside weatherstrip5. Rear door panel6. Rear door belt outside weatherstrip7.
Inspection1.Turn the ignition switch ON.2.Connect the GDS.3.Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.4.The voltage will rise with higher intensive light and reduce with lower intensive light.1. Auto light signal2.
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper